Experiment With The HyperRestore DA

[forescore]

I ordered a selection of big toe bands a while ago and they arrived yesterday. So...what does that have to do with my restoration?....Glad that you asked. I wanted to experiment a little with a goal in mind. The photo below shows what I did with the toe band.


My goal here is to maximize lengthwise tension while minimizing the girthwise tension. This is my second day using the band. When I take the valve off to pee, there is a really good release of pressure. If you look carefully just behind the cone, there is a slight bulge there. That is quite a lot of inflation pressure that makes that bulge.

The photo below is how I deal with the device inside my jeans.


This photo shows a pair of my open end elephant 🐘 underwear. This allows the device to hang downward and prevents chaffing that would happen if I were to go commando. Using this setup, it allows me to pull the device and penis out of my jeans fly, removing the valve to deflate, and allowing me to pee through the device. The added advantage of this setup is that the device no longer works its way off resulting in having to reset it, and the air pressure inside remains constant. Prior to this setup, any time I did anything that resulted in squeezing the inflated part of my foreskin, I would get a partial deflation and the skin would slip a little resulting in decreased pressure inside and eventually having to reset the device. I am happy with how this is working so far. I do have to be careful not to overinflate it because it will break the 4 hour rule. My goal is moderate pressure lengthwise for 14 to 16 hours a day.

[Matt]

Well how is your experiment going? I’m wearing my retainer a lot more lately

[forescore]

The experiment is continuing which means that I am liking how it is going. The band in the photo I cut in half which makes it a lot easier to place it. It is just as effective at half the length. I'll have to link to the banding material. I got 3 different packages of banding. Two turned out to be the same banding but one was more economical. I like the banding that has a very soft silicone layer on the inside. Besides being comfortable, it holds the material together when it is cut to length. As pictured, I am placing it close to the device. It allows a good amount of inflation without a huge bulge which also means that the stress is lengthwise and not girthwise. Finally, without the band in there my inflation created a huge bulge and once I put pants on, I couldn't keep air in the thing and constantly had to reinflate. The band has solved that problem. It stays inflated really well until I have to remove the valve to pee.

[Matt]

Great update thanks !

[forescore]

A minor update. Today with the smaller band, I moved it closer to the device. When I inflated I got minor bulge on both sides of the band, which was one of my objectives. I'm pretty sure now that I'm getting lengthwise tension along the whole length from the trap point at the device to the anchor point at the corona ridge. That was one of my goals in the experiment.

[Matt]

Could this also be done using a Tlc-x air with a balloon attached?

[forescore]

My first thought is yes. If you put a soft band in the middle, both sides of the band will inflate causing the band to lift a tiny bit limiting girthwise expansion of your skin and focusing the tension lengthwise. I'll go get a link to the material that I am making the band from and post it here.

[forescore]

The tubes, as stated are cutable and they are reusable. The inside is a layer of very soft and squishy silicone. It is very comfortable on my shaft. I have a ¼ inch of it there at the moment.

So, technically does make my dick toed? 🤔 😜

Cuttable Toe Tubes Sleeves, 5 Pack, Made of Elastic Fabric Lined with Silicone Gel. Toe Sleeve Protectors Relief Toe Pressure Pain, Corn and Calluses Remover (for Big Toe, 15cm Length) https://a.co/d/aqFONjd

[Matt]

Ha ha you’re hilarious !!!

[forescore]

I sprung for the longer ones. That'll keep my dick big-toed for a very long time....me thinks...🤣

[forescore]

I figured that if I'm going to spend this much time making a new foreskin I'm always thinking of ways to maximize the rate of growth lengthwise. This additional piece qualifies for that purpose.

[forescore]

I just discovered something really cool about doing this banding. I just got done peeing through the device, put the valve back on and started reinflating. Since the area being inflated is inside the trunk of my elephant underwear, I can't tell how big the inflation is and with the larger band I was depending on how it felt as a relative indicator of inflation pressure. Now, with the smaller band and inflation on both sides of it, when the band opened the back area it made a tight assed fart sound and I inflated just a small amount past that and could feel the band expand slightly. Man, what a great indication of the amount of pressure that I want on the inflation!

A fart on every inflation....who'd of thought! 🤣😍

[Matt]

Ha ha !!!! Good thing we can laugh at ourselves!!!! We’ll keep us updated. I may want to try this contraption out !!

[forescore]

I'm having way too much fun with this....but restoration is like watching grass grow, so you have to pass the time somehow. Might as well be with humor. It goes with my character. I've always been this way. It is why I had so much fun teaching high-school for 35 years.

[Matt]

You must have a lot more patience than I do !!