Announcement

Collapse
No announcement yet.

Uneven taping

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • parsecskin
    replied
    No, I've got some in my bathroom somewhere I think. Whether the package is still there or not is a whole nother issue. I'll get back to you later on.

    Leave a comment:


  • Tormod
    replied
    Originally posted by parsecskin View Post
    I did find a tape that was very similar to Mefix that worked as well, but I forget what brand it was. Do some research, there are others out there if you can't find original Mefix.
    Rejuveness?

    https://www.rejuveness.com/rejuvenes...llergenic-tape
    Last edited by Tormod; 05-22-2018, 12:52 AM. Reason: Edited to include link

    Leave a comment:


  • parsecskin
    replied
    I did find a tape that was very similar to Mefix that worked as well, but I forget what brand it was. Do some research, there are others out there if you can't find original Mefix.

    Leave a comment:


  • Transmogrify
    replied
    I second the Mefix tape. I restored for a while a decade ago, when everyone recommended that micropore tape. I never had good luck with any of the brands. Mefix has the perfect amount of adhesion for my skin. And, when it's time to remove the tape, you can just wrap your junk with a warm, wet washcloth. The fabric backing of the tape lets the water soak through to dissolve the adhesive for easy removal.

    Leave a comment:


  • parsecskin
    replied
    Ain't nothing like Mefix. Not even close.

    Leave a comment:


  • Sean300
    replied
    Originally posted by Transmogrify View Post
    I apply the tape so that the seam is on the underside where there's less tension - otherwise it will start to pull up on the top where the force is greater. I pre-make the tapes in batches, using wax paper as a backer. First, I peel the wax paper off, then get an erection. Then, center the taper and position, and circle it around with the seam meeting perfectly at the bottom.

    As for that tab, I make mine with the tab too, but it's pretty useless with the Mefix tape I use. For me, it's best just to fold those two prongs together to keep them from adhering to the skin and underside of my glans (ouch). I measure the tape to fit my erect girth precisely, so that extra flap is really only useful in helping to peel the tape from the wax paper backer I use.

    For me, making the tape ahead of time is key in getting a good application without any fuss.
    I think that ur solution is good. I will try to apply it from below and not from above.
    I use micropore tape which was recorecomme by the foreskin rerestoration forum in my country.

    Leave a comment:


  • gdom
    replied
    I think you're using bad tape.

    Leave a comment:


  • Tormod
    replied
    The crucial features of the T-tape method are probably:
    1. Pre-make the T-tape (I used Mefix tape) of a length so that it goes around your ERECT penis. Overlapping tabs are extra.
    Applying the T-tape
    2. Wash and dry the skin. When flaccid/soft locate and mark 4 or 5 points on your line of equilibrium around the shaft. Pinch grip skin and pull forwards. Roll the skin between index finger and thumb until the skin is furthest out - the tensions on inner tube and outer tube should feel about equal. This is shown in the T-tape video at ttape.tumblr.com
    3. Get erect. Pull skin towards your belly. Apply the T-tape with its centre line as near as possible to the points on the line of equilibrium. Overlap the tabs.
    4. Leave for maybe 5 minutes before tensioning.

    Hope this helps

    Leave a comment:


  • parsecskin
    replied
    What kind of tape is that? Mefix is THE ONLY type to use for this. DO NOT USE DUCT TAPE!!!

    Leave a comment:


  • Transmogrify
    replied
    I apply the tape so that the seam is on the underside where there's less tension - otherwise it will start to pull up on the top where the force is greater. I pre-make the tapes in batches, using wax paper as a backer. First, I peel the wax paper off, then get an erection. Then, center the taper and position, and circle it around with the seam meeting perfectly at the bottom.

    As for that tab, I make mine with the tab too, but it's pretty useless with the Mefix tape I use. For me, it's best just to fold those two prongs together to keep them from adhering to the skin and underside of my glans (ouch). I measure the tape to fit my erect girth precisely, so that extra flap is really only useful in helping to peel the tape from the wax paper backer I use.

    For me, making the tape ahead of time is key in getting a good application without any fuss.

    Leave a comment:


  • Sean300
    started a topic Uneven taping

    Uneven taping

    Hi. I have just recently started using the t-tape method, but for some reason i can't manage to apply it evenly. As you can see, the ens of the tape which im holding, doesn't stick to the tape. It only sticks to the skin.
Working...
X